Setup Guide

Doc. No.
Rev.
Date
1.50
2022-08-17
Damm Cellular Systems A/S, Denmark
BS422 Installation and Setup guideline
BS422 Installation and setup guideline - Specifications subject to change without notice 3
North America regulations
The Base Station Transceivers and products devices mentioned in this User Manual comply to
FCC part 90 and Industry Canada (IC) RS119 regulations for such equipment.
The equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. The
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause interference to radio communications.
Canadian regulations
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.
RF Exposure
The DAMM developed transmitting devices mentioned in this User Manual have the Nemko
approval concerning “Maximum Permissible Exposure Calculations” which are the European
limits for maximum permissible exposure defined in the document 1999/519/EC, Council
Recommendation of 12. July 1999. A summary of the results is listed below. The specific
Nemko Document 128948/5 and 365007-07r01 can be obtained by request from the DAMM
Support Department.