User Guide

Dugan Models E-1 and E-1A User Guide
20
Configuration
Power-up Commands
The Model E-1A can execute one of five commands during each power-up. Select the
command by holding down a specific button during the entire power-up process,
which takes just a few seconds. Power-up is complete after the LEDs stop flashing.
To execute more than one command, turn the unit off after it finishes powering up,
and repeat for the next command.
Table 3-1 Power-up commands
*These buttons perform startup commands on the Model E, not the Model E-1A
Reset
Hold down the channel 1 bypass button to set all parameters to factory default set-
tings and clear label text. We recommend executing this command (just like “zeroing
out” a console) before starting a new installation.
channel 1 channel 2 channel 3* channel 4
bypass
System Reset DHCP On N/A 16 channel mode
mute
Network Reset N/A N/A 8 channel mode