SDS

Page 3 of 6

ventilation. Carefully collect batteries and place in an appropriate container for disposal. Remove spilled liquid with

absorbent and contain for disposal.

SECTION 7: HANDLING AND STORAGE

Avoid mechanical or electrical abuse. DO NOT short circuit or install incorrectly. Batteries may explode, pyrolize or

vent if disassembled, crushed, recharged or exposed to high temperatures. Install batteries in accordance with equipment

instructions. Replace all batteries in equipment at the same time. Do not carry batteries loose in a pocket or bag.

Storage: Store batteries in a dry place at normal room temperature.

SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION

The following occupational exposure limits are provided for informational purposes. No exposure to the battery

components should occur during normal consumer use.

Chemical Name Exposure Limits

Manganese Dioxide 5 mg/m

Ceiling OSHA PEL

0.2 mg/m

TWA ACGIH TLV

Propylene Carbonate 2 mg/m

Ceiling ACGIH TLV

Lithium None established

Graphite (synthetic non-fibrous)) 5 mg/m

TWA (respirable dust), 15 mg/m3 TWA

(total dust) OSHA PEL

2 mg/m

TWA (respirable dust) ACGIH TLV

1,2-Dimethoxyethane None established.

Lithium Perchlorate None established

Ventilation: No special ventilation is needed for normal use.

Respiratory Protection: None required for normal use.

Skin Protection: None required for normal use. Use butyl rubber gloves when handling leaking batteries.

Eye Protection: None required for normal use. Wear safety goggles when handling leaking batteries.

SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES

Appearance and Odor: Coin cells.

Specific Gravity: Not applicable Boiling Point: Not applicable

Water Solubility: Insoluble Melting Point: Not applicable

Vapor Pressure: Not applicable Flash Point: 29°F (-2°C) (1,2-Dimethoxyethane)

Vapor Density: Not applicable Autoignition Point: Not applicable

SECTION 10: STABILITY AND REACTIVITY

Stability: This product is stable.

Incompatibility/Conditions to Avoid: Contents are incompatible with strong oxidizing agents. Do not heat, crush,

disassemble, short circuit or recharge.

Hazardous Decomposition Products: Thermal decomposition may produce hazardous fumes of lithium and

manganese; oxides of carbon and other toxic by-products.

Hazardous Polymerization: Will not occur