User manual

Page 17
9. Break the screws to the right length
Depending on which spacer or spacer combination you
chose, it is now important that the screws that fasten the
cylinder to the back plate have the right length. Use this
chart to nd the right length:
Use a wirecutter, two pliers or bend the screws forth and
back several times in a vice to break them.
No spacers cut 30 mm
5 mm spacer cut 25 mm
10 mm spacer cut 20 mm
5+10 mm spacers cut 15 mm
10+10 mm spacers cut 10 mm
30 mm
25 mm
20 mm
15 mm
10 mm