Technical Manual

V3-BTZBE
Danalock V3-BTZBE, Technical Manual v.2.3, February 2019 Page 19
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
NOTICE statements according to CFR 47 Part 15.21:
Changes or modifications made to this equipment not expressly approved by Poly-Control
ApS may void the FCC authorization to operate this equipment.
Statements according to CFR 47 Part 2.1091 and RSS-102:
With respect to radiofrequency radiation exposure Information it is declared that this
equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with minimum distance of 20 cm
between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclarations selon le CFR 47 Sections 2.1091 and RSS-102 :
Respectant les informations relatives à l'exposition aux radiations de fréquences radio, on
déclare que cet équipement respecte les limites d'exposition aux radiations de la FCC aux
conditions prévues pour un environnement non contrôlé.
Cet équipement doit être installé et fonctionner à une distance minimale de 20 cm
entre l'appareil irradiant et votre corps.
Cet émetteur ne doit pas être installé ou utilisé en conjonction avec d'autres
antennes ou d'autres émetteurs.
AUS/NZ:
The device complies with the AS/NZS 4268 requirements for Bluetooth LE
transceiver under the Radiocommunications Act 1992; Radio communications (Low
Interference Potential Devices) Class Licence 2015 compilation 2016 May 4
Japan:
The device complies with the requirements of the ordinance regulating Radio
Equipment (2005-08), Art2. item 19 for Bluetooth LE applications.
EC/ International
The device complies with the essential requirements of the RED directive
2014/53/EU directive with respect to the EMC requirements, safety and radio
spectrum matters.
The device complies with the essential requirements of the 2011/65/EC directive on
the restriction of the use of certain hazardous substances in electrical and electronic
equipment (ROHS2).
The device complies with the essential requirements of the EC 1907/2006
regulation concerning the Registration, Evaluation, Authorization and Restriction of
Chemicals (REACH).