Use and Care Manual

3. Continuous draining using a pump:

Water can be automatically emptied into a ﬂ oor drain or suitable

drainage receptacle by inserting the supplied pump hose in to the drain

pump outlet. Ensure the continuous drain hose is not installed to the

unit and that the plastic cover is securely placed on the continuous

drain outlet. Insert the pump drain hose into the drain pump outlet en-

suring there is a depth of at least 15 mm. Once properly inserted lead

the pump hose to the ﬂ oor drain. Once the hose is placed where water

can easily drain out, press the “Pump” button on the control panel to

activate the pump draining feature. To remove the pump hose, press

the “Pump” button again on the control panel and remove the hose in

the reverse order of installing it.

Note: It is normal for the pump to make a little bit of noise when it is

running. Ensure there are no bends or kinks in the hose that will stop

the water from ﬂ owing freely.

Note: If the “Pump” indicator light is ﬂ ashing that means that the pump

has failed to operate.

• Check that the pump ﬁ lter is clean, to check the pump ﬁ lter, turn

the unit off and unplug it, remove the water bucket from the unit,

pull the pump down, gently pull the ﬁ lter off and clean the ﬁ lter if

needed. Once clean, reinstall the ﬁ lter by reversing how it came off

and gently pushing the pump back in to place.

• Check that the pump hose is not kinked or blocked.

• Empty the water in the bucket.

• If the pump hose has dropped, reinstall it.

Operating Instructions

REMOVING COLLECTED WATER

Pump drain

hose

Pump drain

hose outlet

Pump filter

Install the pump

drain hose in

the pump

outlet

To remove, press the pump outlet in

and remove the drain hose