Owner's Manual

9
STARTING A WASH CYCLE
1. Load the dishwasher as per the loading
instructions.
2. Add detergent and rinse aid as required.
3. Close the dishwasher door and press the power
button to turn on the appliance.
4. Press the Program button repeatedly to choose
the desired wash program.
5. Press the Sanitize button to select the sanitize
function.
6. Run the hot water faucet nearest the appliance
until the water is hot and then turn it off.
7. Press the Start/Pause/Cancel button to begin the
cycle.
CHANGING THE PROGRAM MID CYCLE
A program can only be changed if it has been
running for a short time otherwise the detergent
may have already been released and the
dishwasher may have already drained the wash
water. If this is the case the dishwasher needs to be
reset and the detergent dispenser must be refi lled.
To change a program mid cycle:
1. Press and hold the Start/Pause/Cancel button
for 3 seconds to cancel the current program.
2. Press the program button to select the desired
program.
3. Press the Start/Pause/Cancel button to start the
new program.
OPERATING INSTRUCTIONS CARE & MAINTENANCE
ADDING A FORGOTTEN DISH
A forgotten dish can be added to a running cycle
any time before the detergent dispenser has
opened. If the detergent has already been released
into the appliance, it is recommended not to add
more dishes as they will not receive adequate
cleaning.
To add a dish:
1. Open door slightly and wait a few seconds
until the wash action stops before completely
opening.
2. Add the forgotten item.
3. Close the door fi rmly to latch and press the
Start/Pause/Cancel button to resume the
program. The program will resume after a ten
second pause.
Caution: Wait until wash action completely stops
before opening the door. Hot water may splash out
of the dishwasher and can cause injury.
CLEANING
• After every wash, leave the door slightly open so
that moisture and odors are not trapped inside
the appliance.
• Only use a soft cloth and mild detergent to
clean the appliance. Never use solvents or
abrasive cleaning agents as this can damage the
appliance.
• To remove water spots from the interior of the
appliance, use a soft cloth dampened with a
small amount of vinegar.
• If the appliance will not be used for a long
period of time, it is recommended to run a
normal wash cycle with the dishwasher empty
and then leave the door open until the interior
of the appliance is completely dry. This will help
the door seals last longer and will help prevent
odors from forming inside the appliance.
• Clean the door seals with a damp sponge
regularly to prevent odors from food particles
that can become trapped in the door seal.