Use and Care Manual

Installation Instructions - Integrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Tools You Will
Need
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
• Remove the screws (see Fig.1. number (2) 4 screws total) from the
compressor back cover and take out the compressor cover (see
Fig.1. number 1) before installing the unit. Please keep all
components that you take out from the back of the unit. (Fig.1)
• Keep the spare caster
• It is recommended that you do not install the outdoor all refrigerator
into a corner (i.e. directly beside a wall). This is to allow the door(s)
to have a greater then 90° opening swing. A limited door swing will
prevent the shelves from sliding out as intended, and may lead to
damaging the door gasket(s).
• The rough cabinet opening must be on a level floor area and at least
26” deep by 24” wide. The opening should also have a height of at
least 34 2/4”.
• The electrical outlet may be positioned from within either side of the
adjacent cabinetry, or the rear of the shaded area (as shown in Fig
2.).
• If the electrical outlet is located inside the adjacent cabinetry, cut a
1-1/2” diameter hole to admit the power cord. If the cabinet wall is
metal, the hole edge must be covered with a bushing or grommet.
1
2
BACK
Fig.1
BACK
1
1
/2”d iam. hole
*If electrical out-
let is in adjacent
cabinetry.
34
3
/4” from
underside
of
countertop
to floor
Cabinets
square
and
plumb
Fig A
24”
34 2/4” from
underside of
countertop to
floor.
Cabinets
square
and plumb
1 1/2” diam. hole
* If electrical outlet
is in adjacent
cabinetry.
Electrical Access
Fig.2
26”
*NOTE: Your outdoor all refrigerator can be built in. The unit may not be energy star compliant
once built in.
9