Use and Care Manual

Trouble Shooting
Problem Possible Cause What to do
be blown or the circuit
wall outlet
Door(s) not shut properly Ensure that the doors are fully closed
against the cabinets. Open the doors
only as needed and for short periods
Exhaust vent is obstructed Verify there is nothing blocking the
to the cabinet same time. Attempt to phase in the
load introduction if possible. (i.e. load
no more than 6 warm bottles at once-
3 per compartment)
Condensation on the High humidity conditions The condensation will subside once
Door(s) not shut properly Ensure that the doors are fully closed
against the cabinets. Open the doors
only as needed and for short periods
breaker tripped
Power surge
Unplug the Beverage Center, wait a few
too warm
Cabinet Temperature Temperature setting Verify the temperature control setting.
being introduced to the cabinet at the
quantity of warm beverages
Recently added a large Limit the quantity of warm beverages
of time
cabinet and/or doors in the home humidity conditions return to normal
front mounted exhausting vent
of time
Beverage Center is fully inserted into outlet
seconds and then plug it back in
No Power A fuse in your home may Replace fuse or reset circuit breaker
Adjust if necessary
or opened excessively and that the gaskets are sealing
or opened excessively and that the gaskets are sealing
guide for a possible solution. If the unit continues to operate improperly, call an authorized service
depot or Danby’s Toll Free Number 1-800-263-2629 for assistance.
Plug not fully inserted into Make sure the 3-prong plug on the
11
Occasionally, a problem is minor and a service call may not be necessary - use this troubleshooting