User manual

18
MAINTENANCE NOTICE
- To protect the normal use of all accessories, please kindly make sure understand and pay attention to
following points.
- Power input is 100V~240V,output 12V/3A.
- Under normal working status, power adapter will keep warming, but body temperature of 60 degree or
under is normal.
- Please be sure of aeration under normal working status, do not put the device in bed, sofa, or similar
area where cooling effect is no good.
- Please do not teardown personally, but send it back to the pointed service agent, or there will be danger
of electronic shock.
- Please pull out the cable and shut the device immediately when cable broken or liquid in, and send to
pointed agent for repair.
FAQ
1. Q. The hard disk can not be recognized under Windows 2000 / Windows XP operation system.
Which remind the connected device can not be recognized.
A. It may because the original USB driver gets lost. Please reinstall your operation system, re-
search the driver disk or serve the internet to research the USB2.0 driver procedure.
2. Q. Portable hard disk is available but the speed is very slow and takes a long time to copy data
A. Please check the USB terminal version of the PC
Q. Can it copy between the USB peripheral device through USB?
A. No, it can’t (Available with the future firmware).
3. Q. When I try to disconnect the USB device, I keep on getting The device Generic volume cannot
be stopped right now. Try stopping the device again later message, what should I do?
A. Close any program that might be accessing data on the player, including Windows® Explorer. If
it does not work, close all programs and wait for another 20 seconds, then try the green arrow icon again.
If it still does not work, you should shut down the player and disconnect the USB cable.
4. Q: Why is the use of USB HOST external storage devices to play video files will be mosaic pheno-
menon?
A: The product of USB HOST is the USB 2.0 Full-speed interface, the player may have a greater rate
of the video file will be the speed restrictions.
5. Q: Can it be turned off when connect to PC?
A. No, it can’t (available with the future firmware).
6. Q. During power on, why the TV will have a short flash, blue screen or screensaver?
A. This is normal, when the system initialize, it will setup the corresponding parameters so it can
output the correct video signal to the TV, during the initializing time, the TV will receive incorrect signals
or the signals will not be stable and will cause the TV screen to flash, some TV will treat it as no signal,
and will display a blue screen or screensaver.
7. Q. Why there is no sound in movie, music playback when using YPbPr output?
A. YPbPr output is a video output only, and does not include sound signals, when using YPbPr
output, please plug the AV OUT or the S/PDIF jack to output sounds.