User Manual

REPEAT:
Adjusts the number
of echoes
MIX:
Adjusts the amount
of echo effect
BATTERY: Uses one S-006P 9-Volt Battery. Danelectro “Vintage Power
Source” batteries are recommended.
BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.
Polarity: Center Negative (-). 300mA maximum. Danelectro “Zero Hum”
Battery Eliminators are recommended.
FAB
Slap Echo
TO BEGIN:
• Install 9-Volt battery (included). If using
Danelectro’s “Zero Hum” adapter (Recommended)
instead of a battery, connect this to the “9V DC”
jack on the back of the D-4.
• Connect an instrument cable from your guitar to
the “Input” jack. Connect a second cable from
the “Output” jack of the D-4 to the input jack of
your amplifier.
• LED light will be on when foot switch is
activated.
CONTROL FUNCTIONS:
REPEAT: This control allows you to set the number
of echoes…from one echo (a single “slap”) at
the minimum setting to a great number of echoes
at the maximum setting.
MIX: This control allows you to mix in some dry
signal with the delayed signal. At minimum set-
ting, there will be almost no echo effect. At
maximum, there will be only the echo sound.
D-4 Instructions
INPUT 9VDC OUTPUT