BLUETOOTH TURNTABLE WITH SPEAKERS User Manual TE-2017 Automatic Belt-Drive Turntable After sales: danfi.audio@outlook.
IMPORTANT SAFETY INSTRUCTIONS This symbol indicates that dangerous voltage constituting a risk of electric shock is present within the unit. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying the unit. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use the speakers near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.
BEFORE USING THE UNIT As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician. Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat.
LOCATION OF CONTROLS 1. 2. 3. 4. 5. Dust cover Turntable Platter 45 RPM adaptor Tone arm lift lever Tone arm 6. 7. 8. 9.
10. Speakers 11. LED Display 12. Aux in jack 15. Next music or FM program switch 16. Button- Play modes select key/ Record button 17. TF connector 18. USB connector 19. Hinges 20. FM Antenna 21. LINE OUT jacks 22. DC In jack 13. 14.
FUNCTION 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 3 speeds: 33 , 45 , 78 RPM Built-in stereo speakers with great sound High quality cartridge and stylus Belt driven turntable mechanism Auto stop function RCA audio out USB and TF card slot Transferring vinyl records to USB or TF card Bluetooth connection 3.5mm Aux input for playing other devices FM radio GETTING STARTED General Operation: 1. Open the top cover : 2. Connected the unit to AC power as instruct below.
2. Unlock the tone arm from the holder as the illustrated above. 3. Place the record on the center spindle. 4. Note: If you are playing a 45 RPM Single (small size record), place the supplied 45 RPM adapter(3) to the center spindle then place the record on it. 5. Slide the Speed selector (6) to 33 45 or 78 to match the play speed of the record. 6. Set the auto stop control (7) to ON if you want the turntable to stop turning when it has reached the end of the record.
(Lift up the tone arm and put it on the rest) Turn on the Power Switch (8), then press “ M” button (16)till enter into FM mode. The display (11) shows “ FM 87.5 MHz” . Release the FM antenna (20) and adjust the position to get . Press the button (14) to mute the sound . Press again to restore the sound. Press and hole the button (14) to automatic search FM radio. The tracks will be saved as P01, P02, P03 ... when finished scan. Press the Button (13) or (15) to select previous or next track.
Clear recorder music. Press and hold the button (14) , the display will show “dEL”, then press the button (14) again. You will hear beep sound twice , the currently playing music will be deleted. MAINTENANCE How to replace the stylus The stylus should last about 50 hours under normal use. However, it is recommended that the stylus be replaced as soon as you notice a change in sound quality Removing an old stylus: 1. Set a screwdriver at the tip of the stylus and push down to the direction "A". 2.
TROUBLE SHOOTING GUIDE PROBLEM POSSIBLE CAUSE REMEDY GENERAL No sound in general. Volume not adjusted. Adjust the Volume knob. Source mode in wrong position. Using the Mode button, select the proper function as required. Power cable disconnected or loose. Check the connection or the Power cable. Under the influence of electrostatic phenomenon, the product may malfunction and require user to disconnect Turn off the unit, disconnect the mains plug, and reconnect after a few seconds.