User Manual

5
GETTING STARTED
General Operation:
1. Open the dust cover,and remove the stylus cover
Connected the unit to an AC power outlet with 12V DC adaptor(included in package).Connect the DC
connector to the “DC12V” jack ⑭ on the rear of the unit.
2. Turn the Power ON-OFF/Volume button ⑩ clockwise to power on the unit and set the volume to the
desired level.
3. When you have finished listening to the unit, turn the Power ON-OFF-/Volume button
counterclockwise until LED light is off.
4. Cover with dust cover.
Amplifier Connection (if required)
Whilst you can listen to your table top Bluetooth turntable using the built in speakers, you may also wish to
connect it to your existing Hi-Fi system. Connect the “ out” RCA ports to the “line input” on your mixer or
amplifier using an RCA cable (not supplied).
● Red plug into the Right Channel Input .
● White plug into Left Channel Input.
Playing a record
1. For first time use, take off the protection cover of stylus, unlock the tone arm from the holder.
2. Place the Record on the center spindle.
3. Note: If you are playing a 45 RPM Single (small size record), place the supplied 45 RPM adapter to the
center spindle then place the record on it.
4. Slide the speed selector⑤ to match the play speed of the record.
5. Set the auto stop control ⑥ to ON if you want the turntable to stop turning when it has reached the
end of the record. If the switch is set to OFF , the turntable will continue turning at the end of the
record.
6. Turn on the Power ON-OFF/Volume button ⑩ to on position, which will come to the LED light
automatically, take note the switch also controls the volume.
7. Adjust the function selection button ⑨ to the PHONO position,then the button will display orange light.
8. Raise the Lever to raise the Tone Arm ④ then move it to the top of the desired location of the record.
Release the Lever to put the Tone Arm onto the record. Playing will start automatically.
9. Twist the needle pressure regulator ⑮ to adjust the appropriate stylus pressure to a sound you feel
comfortable.
10. When the record has stopped playing, the turntable will stop automatically if the Auto stop switch is in
the ‘ON’ position. If the Auto stop switch is set to the “OFF’ position, the turntable will continue turning
at the end of therecord.
11. Raise the Lever to raise the Tone Arm ④ then put it back to the Tone Arm Holder position. Release the
Lever then lock the Tone Arm on the Holder.
1. Dust Cover
2. 45 RPM adaptor
3. Tone arm
4. Tone arm lift lever
5. Speed selection switch
6. Auto stop ON/OFF switch
7. Stylus
8. Turntable Platter
9. Bluetooth/Phono/AUX mode selection knob
10. Power ON-OFF/Volume control knob
11. AUX in jack
12. Output Right channel
13. Output left channel
14. DC power input jack
15. Needle pressure regulator(Counterweight)