Installation guide

Danfoss Heating

To perform a standard copy operation:

a) Press CH to select the channel.

b) Press PROG to go to event programming.

c) Press DAY/HOL to select the day to copy to.

d) Press COPY/i to copy the previous day’s events to the displayed

day.

Advanced Copy

The Advanced Copy function is available in 7 day mode only. This

allows any day to be copied to any other day, or days.

To use the Advanced Copy function, go into the event programming

using the PROG button, then:

1) Press DAY/HOL to select the day to be copied from.

2) Press COPY/i to copy from the selected day.

When selected, the day will begin to  ash.

3) Press DAY/HOL to select the day to be copied to.

4) Press COPY/i to copy to the selected day.

5) Repeat steps 3 and 4 to select and copy other days.

6) To stop copying, use the DAY/HOL button to go back to the

 ashing day and press the COPY/i button. The previously

 ashing day will stop  ashing to indicate it has been de-selected.

NOTE: When a day has been copied to, it will remain visible and not

 ashing when the DAY/HOL button is used to select other days.

Channel Copy

Channel Copy is used to copy events from one channel to another

channel.

To perform a Channel Copy operation:

a) Press CH to select the channel to copy to.

b) Press COPY/i to copy from the previous channel.