Operation Manual

Danfoss Heating Solutions
7
UK
DE
DK
NL
3. Installation - step by step
3.3 Configuring Danfoss Link
TM
CC
For practical reasons, it is recommended that the
Danfoss Link
TM
CC is connected to a battery pack
(014G0262). This makes the device mobile, and it can
then easily be positioned at a distance of up to 1.5 m
from each radiator thermostat that is to be added to
the system.
Remove the front cover from the Danfoss Link
TM
CC
by carefully levering it off, starting with the bottom
corners. Press and hold down the setup button using
a ballpoint pen for approximately three seconds to
start the installation menu (the start-up phase may
take several minutes).
For Help, press ? in the lower right corner.
For installation without a battery pack, please see
www.danfoss.com/living.