Installation Guide

Refrigerants Temperature range Max. working pressure

Mounting

Filter installation

Danfoss

23Z11.12

Min. 5% Ag

PS / MWP = 35 bar / 500 psig

-40 – 70 °C

-40 – 160 °F

R134a, R404A, R407C, R507, R22,

R410A and other refrigerants

(HCFC, HFC, HFO, HC)

Install burnout drier as close as possible to the compressor.

Installation guide

ELIMINATOR® Hermetic burn-out lter drier

Type DAS

023R9527

PAGE 1
Installation guide Refrigerants Temperature range R134a, R404A, R407C, R507, R22, R410A and other refrigerants (HCFC, HFC, HFO, HC) -40 – 70 °C -40 – 160 °F Max. working pressure PS / MWP = 35 bar / 500 psig Mounting Filter installation Danfoss 23Z11.12 Min. 5% Ag Install burnout drier as close as possible to the compressor. © Danfoss | Climate Solutions | 2021.
PAGE 2
Schrader valve Installation 1 Nm (5 in.-lbs) Danfoss 23Z12.13 ≤ 50 °C (250 °F) Initial pressure drop: Record initial pressure drop and check again after 72 hours of operation. Replace drier if the pressure drop ([bar] / [psi]) across the core exceeds the following values. Evaporator temperature Refrigerant -40 °C / -40 °F -28.9 °C / -20 °F -17.8 °C / 0 °F -6.7 °C / 20 °F 4.4 °C / 40 °F [bar] [psi] [bar] [psi] [bar] [psi] [bar] [psi] [bar] [psi] 0.04 0.50 0.07 1.00 0.10 1.50 0.