Installation manual

Starting up
Initial startup of Solar-Log200
Solar-Log
1000/500/200
Installation 141 of 268
7.2 Initial startup of Solar-Log
200
The Solar-Log
200
is configured completely through a connected PC or laptop.
Requirements
 All cables and accessories (if any) have been connected to the Solar-Log
200
.
 The Solar-Log
200
is connected to an internet router.
 The DHCP service is enabled on the internet router.
 DHCP is also enabled on the PC or laptop.
Easy Installation
From firmware version 2.4.0 the initial start up can be carried out with the Easy In-
stallation configuration wizard depending on the language and country selected.
However, Easy Installation can currently only be used with certain inverters.
The Solar-Log™ then carries out the initial start up intuitively step by step:
For more information, please refer to the Quick Start Guide supplied.
Initial configuration
The initial configuration of Solar-Log
200
is made through a Web browser.
1 Enter the address http://solar-log in the address bar of the web browser.
 A selection of national languages is displayed.
2 Select the desired language
 The welcome screen then appears.