Installation manual

Solar-Log1000: Configuration at the unit
Configuring the inverter data (Basic/Inverter)
Solar-Log
1000/500/200
Installation 231 of 268
Procedure
To configure the limit values for fault messages, and the messaging in general:
1 Select the message form (Relay, EMail and/or SMS).
2 Touch the input box beside From deviation of
 The virtual keyboard is opened.
3 Enter the lower limit percentage of generator power at which a fault is rec-
ognised, and confirm with OK
4 Touch the input box beside Starting from .. of malfunction
 The virtual keyboard is opened.
5 Enter the lower limit percentage of the fault duration at which a fault is rec-
ognised, and confirm with OK
6 Touch the input box beside Max. number of messages per day
 The virtual keyboard is opened.
7 Enter the maximum number of messages to be sent per day and confirm
with OK
8 Touch Save, then Next to go to the next dialogue.
Configuring the graph display
If configuring through the display, only the Y-axis (power output) of the graph for
the yield data can be set; if configuring from a PC, both the Y-axis (Page 167)
and the X-axis (time of day) can be set (Page 170).
Nothing usually has to be changed here, as Solar-Log
1000
automatically calcu-
lates the values for the generator power input. However, these values can be
adapted to your own data.
Dialogue boxes
 Day, Month, Year, All years
For each period specified, the maximum value to be plotted can be entered
in kW (in W for a day).
The graph on the display and on the PC represents these values on the Y axis.
Changes become effective when a new graph is displayed, or after a dis-
played graph is updated.
Procedure
To set the representation on the Y-axis:
1 Touch the required input box beside Day, Month, Year and/or All years
 The virtual keyboard is opened.
2 Enter the maximum value to be represented on the Y-axis and confirm with OK
3 Touch Save