Installation manual

Solar-Log1000: Configuration at the unit
Selecting a display language (System/Language settings)
Solar-Log
1000/500/200
Installation 251 of 268

Note
After restarting, installation of the firmware can take up to 15 minutes to
complete. Do not switch off the device during this time!
10.21 Selecting a display language (System/Language settings)
The selected display language applies both to the display and the web brows-
er.
To set the display language:
1 Select Config./Internal/Language settings from the menu.
 A dialogue box opens for setting the display language.
2 Touch the desired language
 Solar-Log
1000
changes back to the initial screen, which is now dis-
played in the selected language.
10.22 Country setting (Internal/Country setting)
The country setting sets the currency, date format and time format (inde-
pendently of the language setting).
To configure the country settings:
1 Select Config./Internal/Country settings from the menu.
 A list of countries is displayed for selection.
2 Select the desired country
3 Touch Select to save the country setting.