Technical data

VLT 5000/5000 FLUX SyncPos Quick-Setup
MG.10.Q1.5B – VLT is a registered Danfoss trade mark4
Description in brief
The tire will enter the conveyor belt from the right. This, in turn, will start to run at the same speed as the
previous conveyor belt. When the tire reaches the centering station it will stop. The tire will be centered and
stays in the waiting position until the machine has finished measuring the "previous" tire. When the
measurement is finished, the conveyor and the new tire will be positioned exactly under the spindle. In order
to prevent any slippage of the tire, the acceleration and deceleration of the positioning will be controlled by the
frequency converter in such a way that we obtain the fastest cycle time without slippage of the tire on the
conveyor. A PC is shown connnected to the VLT via RS 485 but this is not needed during normal operation as
the APOS program can be stored in the SyncPos card. This picture only shows the minimum required
components for a simple positioning application.
Typical application example