Manual

16 | DANGEROUS MUSIC
Operation: On the Monitor ST Remote, first use the “UP” and “DOWN” buttons to select the appropriate
bank. The Remote’s LEDs will verify which bank is active. Then choose the input by using the
“Additional Switching” 1-4 buttons. That’s how the Additional Switching remote buttons can
control up to 4 devices. (More than just black magic). See the Remote ST-SR section for photo
ops and visual alacrity.
6. Level Trim Controls
Feature: If you have experience in this department, calibrate the digital signal levels up to a maximum
output of +26 dBu (-22dBFS = +4dBU, or 1.23 vRMS).
Benefit: Monitoring at different levels completely skews your audio judgment. Calibrate all your gear
identically.
Operation: To align the unit, remove the lid as outlined in the “module installation” section. Locate the 6
alignment pots (circled in the photo op above). These are NOT to be confused with the 6 DC offset
nulls below them. Select a 1kHz digital sine wave and feed it at the desired level. Using a small
tweaker flathead screwdriver, gently turn the internal trim pots until they measure +4 dBu at the
output.
Tip: ,The DAC-SR comes aligned from the factory to -18 dBFS = +4 dBU.
Caution: To avoid risk of electrical shock, unplug the unit from power before removing the lid. Exercise
caution as frequently as possible.
Note: See the module installation section for photos.
DAC-SR
Rear Panel Features & Benets
[The Dangerous Music DAC-SR rear panel pictured above, installed in the Additional Switching System Rack]
1
2
3