Manual

25 | DANGEROUS MUSIC
 •Usinga#2phillipsheadscrewdriver,removethefour#6-32 x 1/4” black screws in the rear plate
(5).
Tip:
,Put the screws somewhere where they won’t roll into the shag carpet like a recycled Trader Joes
Salsa Cruda container. You’ll need these in a minute.
STEP 4. Installing the board
 •Whereyoujustremovedtherearpanel,slidetheboardandrearpanelassembly(1)throughthe
rectangular opening.
 •Attachittotherearwiththefour#6-32 x 1/4” black screws removed from rear blank (5).
 •Screwboarddown(13)withfour#6-32 x 3/8” machine screws (3).
 •AttachtheDAC-STface(2)withthefour#4-40 x 1/4” silver screws removed from the front blank
(4).
STEP 5. Wiring the goods
 •Beforeattachingthe20pinlargerIDCribboncable(7),orienttheA.S.S.exactlyasintheprior
photo op and note the red trace, indicating pin 1. Now, connect the ribbon cable to the DAC-ST
PCB (11) with the red trace on the left. Then, connect it to the control PCB (15) with the red trace
on the lower half of the ribbon. Note the gentle fold in the ribbon.
 •Beforeattachingthe12pinsmalleratribboncables(6)orientyourA.S.S.exactlyasintheprior
photo op. Now, noting the blue side of the ribbon connector, connect them between main (12) and
front PCB’s (16).
 •Attachthe2-pinMolexconnectorextendingfromthefrontpanelPCB(2)tothe2-pinheaderon
the Main PCB (15). It will click into place.
STEP 6. Clean up
 •Screwthelidbackonwiththose8blackscrewsyouputintheSalsacontainer.
 •You’redone!Doalittlevictorydanceandcrackthatbeernow.
Tip: ,If you are uncomfortable performing the installation yourself, Dangerous can perform it safely for
you at the factory.