Owner's manual

| III
READ THIS FIRST
DO NOT INCORRECTLY CONNECT MIC PREAMPS TO THE LIAISON!
To avoid damaging your hard won gear and voiding your warranty, follow the simple steps below.
•Do not connect gear equipped with phantom power- such as mic preamps and channel strips -
to the insert loops in your Liaison. Activating the phantom power will damage the electronics in
the monitor and parallel processing paths and void the warranty instantly!
It may also damage other outboard gear that is parked down-stream of the offending piece by
applying the phantom power to the inputs.
A mic pre output as the source connected to either Buss A or Buss B Input is perfectly OK -
phantom power is applied to the INPUT pins of a mic pre.
Correct Path: Mic > Mic Pre Input > Mic Pre Line Out > Liaison Buss Input
•If you cannot follow the rst rule and choose to connect a mic preamp to the Liaison inserts,
DO NOT engage the phantom power.
The Dangerous Music Team