Instruction Manual

Monitor ST rear panel
The Aux Inputs feed the main and cue amp sections and can be used for many purposes.
Three that come to mind immediately are:
1. Mult the vocal mic/EQ/comp signal being fed to the DAW into Aux Inputs for
latency free vocals in the cue system.
2. Feed the audio output of your Mac's enclosure into the Aux input to hear
computer sound previews.
3. Use a mini mixer for both of the above and a click for voice overs and drummer
cue feeds, etc.
4. Set a mic/pre combo up in the recording room for duplex comm during talkback.
Main inputs and outputs:
The Monitor ST uses 25 way ‘D’ connectors for the main input and output connections
wired according to the Tascam standard. The signals are arranged on the connectors as
follows (wiring diagrams on next page).
Input 1 Left and Right on channels 1+2
Input 2 Left and Right on channels 3+4
Input 3 Left and Right on channels 5+6
Input 4 Left and Right on channels 7+8
Speaker 1 Left and Right on channels 1+2
Speaker 2 Left and Right on channels 3+4
Speaker 3 Left and Right on channels 5+6
Sub woofers Left and Right on channels 7+8
DC IN is for the power supply. Don’t hot plug this connector as that will arc the contacts.
TB REMOTE is provided for using a producer’s remote switch available from us or
wired according to the diagram on the next page.
The SLATE output feeds the talkback mic to the DAW or external powered speakers for
cueing the talent. Please note that this signal is unaffected by the TB level control.
The CUE AMP OUT jack feeds a Redco Little Red Cue Box or similar level control
device for talent headphones. www.redco.com
-5-