User's Manual

• Carefully remove the 2 hexagonal screws (3/32”) holding the left panel in place. (SEE PIC A)
• Locate battery harness and attach 9V battery to the connector pad. Do not use force! (SEE PIC B)
• Replace battery in grip frame as shown in illustration C.
• Replace grip frame and screws. Do not over tighten screws!
INSTALLING THE BATTERY
ATTACHING A PAINTBALL LOADER
• Release clamp on feedneck. (SEE PIC A)
• Loosen thumbscrew counterclockwise by hand. (SEE PIC B)
• Insert feed tube of loader unit.
• Close clamp securely. Loader should t snug within feedneck. (SEE PIC C)
• If loader is loose, remove and adjust thumbscrew clockwise.
WARNING
EXCESSIVE FORCE MAY CAUSE DAMAGE TO LOADER OR THE G4!
A B CA B C
W W W . D A N G E R O U S P O W E R . C O M
14 15