Operation Manual

IQ16Q760
A B
Setting the watch to a different time zone:
By pressing button “A” (<3 seconds) the current time zone is displayed. By pressing “A” again
for a shorter period, this time zone can be altered to the one you are currently in. The hands will
then automatically turn to this time zone.
Date and signal strength:
Normally the date can be read in the display. By pressing button “B” ( <3 sec) a seconds
counter will appear, a symbol for an RC tower and a number. The number represents the
number of days since the last signal was received. If it reads “0” , the signal has been received
in the last 24 hours.
Setting the hands:
Press button “B” for more then 3 seconds. The hands should turn to the 12 O‟clock position.
When they don‟t, the hands should be calibrated manually. To do this, press both buttons at the
same time for a few seconds. The letter “H” will appear, indicating that the hour- and minute
hand can be altered. Continue pressing button “A” untill the hour and minute hand have reached
the 12 O‟clock position.
If these hands have been set, press button “B” once. An “S” should appear in the display., which
indicates the seconds hand can be altered. Keep pressing button “A” untill the seconds hand
reaches the 12 O „clock position. If all 3 hands have reached the 12 O‟clock position, press
button “B” once ( > 3 seconds) to return to the normal time. The watch should automatically set
itself to the correct time within a few minutes.
General information
The range of the watch is a radius of approximately 1000 miles from Frankfurt.