Full Product Manual

INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
1. Rotary Hammer Drill Or Similar (If Anchoring)
2. 3/4” Masonry Bit (If Anchoring)
3. Hammer
4. Foot Level
5. Open End Wrench Set: Metric
6. Socket And Ratchet Set: Metric
7. Hex Key / Metric Allen Wrench Set
8. Medium Crescent Wrench
IMPORTANT NOTICE!
These instructions must be followed to ensure proper installation and operation of your lift. Failure
to comply with these instructions can result in serious bodily harm and void product warranty.
Manufacturer will assume no liability for loss or damage of any kind, expressed or implied resulting
from improper installation or use of this product.
STEP 1
( Selecting Site )
BEFORE INSTALLING YOUR NEW LIFT, CHECK THE FOLLOWING:
1. LIFT LOCATION: Always use architects plans when available. Check layout dimension against
floor plan equirements making sure that adequate space is available.
2. OVERHEAD OBSTRUCTIONS: The area where the lift will be located should be free of overhead
obstructions such as heaters, building supports, electrical lines etc.
3.
CLEARANCES: Be sure you have 4' on the Power Unit side and 10' on the opposite end to allow
space to install long safety linkage rods.
IMPORTANT NOTICE!
DO NOT install this lift on any asphalt surface or any surface other than concrete.
DO NOT install this lift on expansion seams or on cracked or defective concrete.
DO NOT install this lift on a elevated floor without first consulting building chitect.
DO NOT install this lift outdoors unless special consideration has been made to protect the power
unit from damp weather conditions.
DO NOT install this lift on slopped floor with mo e than 3
" front to back or 2" side to side.
Page 8
For technical questions, please call 877.432.6627