Instructions / Assembly

A B
145" 17"
MODEL
D2-10C
D2-10A
143.5" 22"
RECOMMENDED BAY DIMENSIONS
16' wide x 24' deep x 12'6" tall
16' wide x 24' deep x 12'6" tall
STEP 4
(Site Layout)
1. Determine which side will be the approach side.
2. Now determine where the power unit will be located. The POWERSIDE column has the power unit
mounting bracket attached to the side. Please note, on the Asymmetric model lifts the POWERSIDE
column will always be located on the passenger side of the vehicle.
3. Once a location is determined, use a carpenters chalk line to layout a grid for the post locations. Keep
all dimensions and squareness within 1/8" or malfunctioning of the lift can occur.
4. After the post locations are properly marked, use a chalk or crayon to make an outline of the posts on
the floor at each location using the post base plates as a template.
5. Double check all dimensions and make sure that the layout is perfectly square.
Chalk line
Chalk line
Use the edge of the base plates to line
up the posts on the D2-10C model.
Use the notched cut outs to line up
the posts on the D2-10A model.
14