Instructions / Assembly

STEP 19
OPERATION INSTRUCTIONS
LIFT OPERATION SAFETY
• DAILY inspect your lift. Never operate if it malfunctions or if it has broken or damaged parts. Use only
qualified lift service personnel and genuine Dannmar parts to make repairs.
• THOROUGHLY train all employees in use and care of lift, using manufacturer’s instructions and “Lifting
It Right” and “Safety Tips” supplied with the lift.
• NEVER allow unauthorized or untrained persons to position vehicle or operate lift.
• PROHIBIT unauthorized persons from being in shop area while lift is in use.
• DO NOT permit anyone on lift or inside vehicle when it is either being raised or lowered.
• ALWAYS keep area around lift free of tools, debris, grease and oil.
• NEVER overload lift. Capacity of lift is shown on nameplate affixed to the lift.
• DO NOT stand in front of the vehicle while it is being positioned in lift bay.
• DO NOT hit or run over lift arms or adapters. This could damage lift or vehicle. Before driving vehicle
into lift bay, position arms and adapters to provide unobstructed entrance onto lift.
• ALWAYS load vehicle on lift carefully. Position the lift adapters to contact at the vehicle manufacturer’s
recommended lift points. Raise lift until adapters contact vehicle. Check adapters for secure contact
with vehicle. Raise lift to desired working height. (See figure 34)
• DO NOT block open or override self closing lift
controls; they are designed to return to the “Off” or
Neutral position when released.
• DO NOT remove or disable arm restraints.
• ALWAYS remain clear of lift when raising or lower-
ing vehicles.
• ALWAYS use safety stands when removing or in-
stalling heavy components.
• DO NOT go under raised vehicle if safety locks are
not engaged.
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY LOCKS ARE ENGAGED BEFORE ENTERING WORK
AREA.
• Hydraulic components that are used on this lift are intended to raise and lower the lift only and are not
meant to be a load holding device. Remain clear of the elevated lift unless visual confirmation is made
that all primary safety locks are fully engaged and the lift is LOWERED onto the safety locks, Refer to
installation /operation manual for proper safety lock procedures and /or further instruction.
• NEVER LEAVE LIFT IN ELEVATED CONDITION unless all Safety Locks are engaged.
• AVOID excessive rocking of vehicle while on lift.
• ALWAYS CLEAR AREA if vehicle is in danger of falling.
VISIT US ON THE WEB AT WWW.DANNMAR.COM30
Never exceed 9"
of adapter height
by any combina-
tion of adapters.
Failure to comply
can result in seri-
ous damage or
personal injury!
Fig: 34
DANGER
DANGER