READ ALLI NSTRUCTI ONS ( Cont ’ d) 19.Car emustbet akenasbur nscanoccurf r om t ouchi nghotpar t s. 20.Adequat event i l at i onshoul dbepr ovi dedwhenwor ki ngonoper at i ngi nt er nalcombust i onengi nes. 21.Keerhai r ,l oosecl ot hi ng,f i nger s,andal lpar t sofbodyawayf r om movi ngpar t s. 22.Useonl yasdescr i bedi nt hi smanual .Useonl ymanuf act ur er ’ sr ecommendedat t achment s. 23.ALWAYSWEARSAFETYGLASSES.Ever ydayeyegl assesonl yhavei mpactr esi st antl enses,t heyar enotsaf et ygl asses.
POWER UNIT LOCATION IMPORTANT The D-12A Alignment Lift MUST be installed in the configuration shown in Figure 1. For the D-12 ONLY, the power unit can be located at either "X" locations shown in Figure 1 or 2. It is important to locate the POWERSIDE runway (with cylinder) on the SAME SIDE as the power unit location. Utility rails on the side of each runway MUST be installed to the inside. NOTE: In order to change the location of the power unit, the cross tubes and the powerside runway must be reversed.
Fig 6 13
(See Fig 10) Fig 10 Fig 13 (See Fig 11-12) (See Fig Fig 14) 14) (See Fig 11 Fig 12 Fig 14 (See Page 15) (See Fig 13) 14
(See Fig 15) (See Fig 17) Fig 15 Fig 17 (See Fig 16) Fig 16 82 (See Fig 18-19) 36 Fig 18 16
Fig 19 Fig 22 Mount the power unit to the mounting bracket using the hex bolts and nylon nuts. Fill reservoir with AW32 HYDRAULIC OIL or DEXRON III or VI ATF (See Fig 20-21) Fig 20 (See Fig 23-24) Fig 23 Fig 24 Fig 21 AW32 hydraulic oil or Dexron III or VI automatic transmission fluid.
(See Fig 28) Fig 28 (See Fig 25) Fig 25 (See Fig 29) Fig 29 (See Fig 26) Fig 26 (See Fig 30) (See Fig 27) Fig 30 Fig 27 18
(See Fig 32) Fig 32 Make sure the power unit reservoir is full with 12qts of AW32 hydraulic oil or Dexron III or VI automatic transmission fluid.
(See Fig 33) Fig 33 (See Fig 34) (See Fig 35) Fig 35 Fig 34 (See Fig 36) Fig 36 21
(See Fig 40-41) Fig 40 (See Fig 37) Fig 37 (See Fig 38) Fig 41 Fig 38 (See Fig 42) Fig 42 (See Fig 39) Fig 39 22
(See Fig 43) (See Fig 43) Fig 43 (See Fig 43) (See Fig 43) (See Fig 43) (See Fig 44) Fig 44 23
Use clean AW32 hydraulic oil or Dexron III or VI automatic fluid only. If ATF is contaminated, flush entire system and replace with clean oil.
GENERAL DISCLAIMER In addition to all claim s listed on each of the following individual W ARRANTY pages, the following GENERAL DISCLAIMERS apply. 1. The purchaser of any DANNMAR product (Buyer) assum es the risk of verifying all m aterials or resources used or relied on.
DANNMAR Term s and conditions of Sale are to be the com plete and exclusive agreem ent (Agreem ent) between the parties superseding all oral or written prior agreem ents and all other com m unications between the parties relating to the subject m atter of said Agreem ent, including statem ents m ade by sales persons. No em ployee of DANNMAR or any other party is authorized to m ake any warranty in addition to those m ade in the Agreem ent.
LIMITED WARRANTY TWO-POST LIFTS/FOUR-POST LIFTS Better Products - Better Service - Better Value Duration: From the date of purchase by original Purchaser or 36/12 months from the date of shipment by DANNMAR or whichever comes first. T Three Years (36-Months) Warranty on the lift structure T One Year (12-Months) Warranty on operating com ponents Limited Warranty 1. Who gives this warranty (Warrantor): DANNMAR EQUIPMENT, 646 Flinn Ave. Moorpark, CA 93021 2.
THI SPAGEI SI NTENTI ONALLYLEFTBLANK.
