Owner`s manual

Canadian Comfort Industries

18 “Glow Boy” Owner’s Manual

MOBILE HOME INSTALLATION

CAUTION: DO NOT INSTALL STOVE IN SLEEPING ROOM

THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR,

CEILING/ROOF MUST BE MAINTAINED!

Your “

GLOW BOY”

Shop and Home Heater has been tested and listed for mobile home installation. It may be

installed in a mobile home as a "Free Standing Stove", a "Hearth Stove", see detailed installation and clearance

requirements in these sections as they imply there.

In addition to all previously detailed installation requirements, mobile home installations must

meet the following requirements:

Permanently bolt your stove to the floor, (A).

Electrically ground your stove or the pedestal to the steel frame of the home. Use a number 8 gauge copper

wire, (B), or equivalent.

The stove must have a permanent outside air source with a ¼ inch screen over the inlet.

For transportation all chimney/vent above the mobile home must be removed.

Chimney/PL Vent must be 3” or 4” PL Vent and must extend a minimum or 36” above the roofline of the

mobile home and must be installed using a UL/ULC listed ceiling fire stop and rain cap.

Note: When moving your Mobile Home, all exterior venting must be removed while Mobile Home

is being relocated. Upon completion of relocation all venting must be reinstalled and securely

Floor Pad

Floor

Frame

(bolts)

(ground wire)

Floor Pad

Combustion Air Intake

Fresh Air Duct

Fresh Air Hood

Stove Exhaust

Pipe Adapter

Clean Out Tee

Tee Support Bracket

Pipe

Firestop Spacer / Ceiling Support

Roof Flashing / Storm Collar

Rain Cap