D222536 Pub No.
Danze always recommends that plumbing products be installed by a licensed professional. Danze aconseja siempre que sea un profesional autorizado quien instale los productos de plomería. Danze recommande que les articles de plomberie soient toujours installés par un professionnel qualifié. Shut off the main water supply before installation by turning the valves clockwise.
5. Apply pipe tape to the inlet port. Slip the coupling nut onto the inlet port and tighten with a wrench. antes de realizar la instalación, cierre el suministro principal de agua girando las válvulas en sentido horario Appliquez du ruban pour tuyau à l'orifice d'entrée. Glissez l'écrou de raccordement sur l'orifice d'entrée et serrez-le à l'aide d'une clé. 6. After installing the faucet, remove the aerator and turn on the water to remove any left over debris. Re-assemble the aerator.
Leaks underneath handle. Lock nut has come loose. Tighten the lock nut. Goteo debajo de la manija. Contratuerca se ha aflojado. Apriete la contratuerca. Fuites sous la manette. L’écrou de blocage s’est desserré. Serrer l’écrou de blocage. Aerator leaks or has an inconsistent water flow pattern. Aerator is dirty or misfitted. Unscrew the aerator to check rubber packing or replace the aerator. El aireador gotea o el chorro de agua está irregular. El aireador está sucio o mal puesto.
Touch Down Drain Installation Instructions Instrucciones para la instalación del desagüe touch down Instructions d’installation de la bonde de vidange manuelle Configuration 1 (metal & 50/50) Configuration 2 (plastic) 1. 2. 1. 2. DA505918 DA505219P DA505207 3. 3. 4. Check to make sure you have the following parts indicated below: Verifique que tenga todas las partes indicadas: Vérifier pour vous assurer que vous possédez les pièces au bas: 5. 6. 4. 5. 1. Stopper / Parador /Tampon 2.
Touch Down Drain Installation Instructions Instrucciones para la instalación del desagüe touch down Instructions d’installation de la bonde de vidange manuelle Étape 2. Installer le tuyau de renvoi 2.1. Configuration 1 (métal ou 50/50): Appliquer de l’enduit d’étanchéité à base de silicone sous le rebord du collet de renvoi (3) et le placer dans l’ouverture du lavabo (3). Configuration 2 (plastique) : NE PAS APPLIQUER L’ENDUIT D’ÉTANCHÉITÉ À BASE DE SILICONE SUR LE REBORD DU COLLET DE RENVOI EN PLASTIQUE.