Installation Guide

Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically
with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
A.B.C D.
6.
Apply pipe tape. Attach the water supply hoses to the
copper inlet tubes of the faucet. (Supply hoses are not included).
Aplique cinta selladora para tuberías. Coloque las mangueras de
suministro de agua en los tubos de cobre de admisión del grifo.
(Las mangueras de suministro no están incluidas).
Appliquez du ruban pour tuyau. Fixez les flexibles d'alimentation en
eau aux tuyaux d'entrée en cuivre du robinet. (Les flexibles d'alimentation
ne sont pas compris.)
7.
Apply the pipe tape to the inlet port. Slip the coupling nuts onto the
inlet port and tighten with a wrench.
Antes de realizar la instalación, cierre el suministro principal de
agua girando las válvulas en sentido horario
Appliquez du ruban pour tuyau à l'orifice d'entrée. Glissez
l'écrou de raccordement sur l'orifice d'entrée et serrez-le à l'aide
d'une clé.
A. Remove the aerator assembly from the spout using the special wrench provided.
Set it aside carefully for re-installation later.
B. Turn on the hot and cold water valves under the sink.
C. Flush out the faucet by running hot and cold water through the spout.
D. Turn off faucet on the sink; carefully re-install the aerator taking care
not to cross thread.
E. Test for satisfactory operation.
A. Quite el conjunto del aireador del vertedor con la llave especial provista.
Póngalo a un lado con cuidado para volverlo a instalar posteriormente.
B. Abra las válvulas de agua caliente y fría debajo del lavabo.
C. Enjuague el grifo haciendo correr el agua caliente y el agua fría por
el vertedor.
D. Cierre el grifo en el lavabo; vuelva a instalar cuidadosamente el aireador
enroscándolo debidamente.
E. Pruebe el grifo para ver si funciona bien.
A. Enlever le brise-jet aérateur sur le bec à l’aide de la clé spéciale fournie.
Le mettre soigneusement de côté pour le réinstaller ultérieurement.
B. Ouvrir les robinets d’eau chaude et froide sous le lavabo.
C. Faire couler l’eau chaude et froide par le bec.
D. Fermer les robinets sous le lavabo; réinstaller soigneusement le brise-jet aérateur
en prenant soin de ne pas le perforer.
E. Vérifier le fonctionnement.
8.