Installation Guide

Adjustable

Wrench

Llave ajustable

Pince à bec effilé

Clé à molette

Needle-nose Pliers

Alicates de extremos finos

Shown/Mostrado/Illustré

D460049/D460050/D460062/D460063

4’’ Square Showerhead

Cabeza de ducha cuadrado de 4 pulg

Pomme de douche carrée de 4 po (10,2cm)

1. Remove the existing showerhead from the shower arm. Clean any debris from inside

the shower arm and shower arm threads. Run the water to flush residual debris from

inside the arm (Fig 1).

2. Wrap the threads of the shower arm with plumber's tape (included) (Fig 2).

3. Attach the new showerhead to the shower arm by turning clockwise. Tighten with a

wrench (Fig 3 & 4).

PAGE 1
4’’ Square Showerhead Cabeza de ducha cuadrado de 4 pulg Pomme de douche carrée de 4 po (10,2cm) Adjustable Wrench Needle-nose Pliers Llave ajustable Alicates de extremos finos Clé à molette Pince à bec effilé 1. Remove the existing showerhead from the shower arm. Clean any debris from inside the shower arm and shower arm threads. Run the water to flush residual debris from inside the arm (Fig 1). 2. Wrap the threads of the shower arm with plumber's tape (included) (Fig 2). 3.
PAGE 2
the 1. Remove the showerhead from the shower arm by unscrewing the ball joint counter-clockwise (Fig 1). 2. The filter screen and flow controller are located at the opening of the showerhead ball joint (Fig 2). Unscrew the filter screen from the ball joint. If necessary, use your needle-nose pliers (Fig 3). 3. Use needle-nose pliers to grasp the flow controller and pull the flow controller out. Take care not to use excessive force when grasping the flow controller so as to avoid damage (Fig 4). 4.
PAGE 3