Installation Guide

the
the
1.
Remove the showerhead from the showerarm by unscrewing the ball
joint counter-clockwise (Fig 1).
4. Remove any debris from the filter screen and from the flow controller.
Reinstall the flow controller by pressing into the opening of the
showerhead. Reinstall the filter screen by screwing clockwise into
the ball joint threads. Reattach the showerhead by screwing the ball
joint clockwise into the showerarm threads. Make sure to follow the
original installation instructions shown above.
2. The filter screen and flow controller are located at the opening of the
showerhead ball joint (Fig 2). Unscrew the filter screen from the ball
joint.
If necessary, use your needle-nose pliers (Fig 3).
3. Use needle-nose pliers to grasp the flow controller and pull the flow
controller out.
Take care not to use excessive force when grasping the
flow controller so as to avoid damage (Fig 4).