Installation Sheet

Adjustable

Wrench

Llave ajustable

Pince à bec effilé

Clé à molette

Needle-nose Pliers

Alicates de extremos finos

Shown/Mostrado/Illustré

1. Remove the existing showerhead from the showerarm. Clean the debris from

the inside of the showerarm and the showerarm threads. Run water to flush

the residual debris from the inside arm (Fig 1).

2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2).

3. Screw the showerarm mount onto the showerarm supply pipe threads (Fig 3).

4. Connect the shower hose to bottom outlet of the showerarm mount and handshower

(Fig 4).

5. Place the handshower with conical attached into the showerarm mount holder (Fig 5).

Douche à main multifonction

Ducha de mano con multifunción

D462024

Multi-Function Handshower

D462025

Surge

PAGE 1
Surge® Multi-Function Handshower Ducha de mano con multifunción Douche à main multifonction Adjustable Wrench Needle-nose Pliers Llave ajustable Alicates de extremos finos Clé à molette Pince à bec effilé 1. Remove the existing showerhead from the showerarm. Clean the debris from the inside of the showerarm and the showerarm threads. Run water to flush the residual debris from the inside arm (Fig 1). 2. Wrap the threads of the showerarm with the plumber's tape (included) (Fig 2). 3.
PAGE 2
1. Remove the showerhead from the hose by unscrewing the hose conical counter-clockwise (Fig 1). 2. The flow controller/check valve is located at the opening of the handshower handle and has a different color plastic housing than the handshower conical threads (Fig 2). Use the needle-nose pliers to grasp the flow controller/check valYe and pull the flow controller/check valve out.
PAGE 3