Operation Manual

7
Clubmate II™
Ordercode: D3264
Main volume control
This control allows you to adjust the total volume level of the clubmate.
Left channel combo line Input
The input equipped with 3 pole XLR/ jack combo socket is electronically balanced to accept the
(line) signal from any mixing console.
115V/230V Switch
Before plugging in the power cord, make sure the 115/230V switch is set to the proper voltage.
Power switch
Do not supply power before the whole system is set up and connected properly. Make sure the
115/230V (9) switch is set to the proper voltage.
IEC connector with integrated fuse holder
This connector is meant for the connection of the supplied main cord. Connect one end of the
power cord to the connector, the other end to the mains, then turn on the Power (10) switch to
operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains. Replace the fuse only with a fuse of same specification (115V:T10A/230V:T5A).
Right channel XLR aux output
This parallel output allows you to connect more bass-cabinets together as well to connect other
systems such as monitor power amplifiers, individual components etc.
To satellite left speakon output
This output is used to connect your left Satellite Speaker.
Left channel RCA line Input
Use this input for connecting a mixer equipped with RCA outputs.
Right channel RCA line Input
Use this input for connecting a mixer equipped with RCA outputs.
To satellite right speakon output
This output is used to connect your right Satellite Speaker.
Right channel XLR full-range output
This parallel output allows you to connect more bass-cabinets together as well to connect other
systems such as monitor power amplifiers, individual components etc.
Overview Satellite
Satellite speakon input
Connect this to the To Satellite (13, 16) output of the subwoofer. Use a good quality speakon cable.
E.g. DAP Audio FS17, FS04, FS14, FS18, FS20, FS21, FS15.