User manual

Ordercode: D1155

CDMP-750

25) FX On/Off button

This button allows you to toggle the effect processor on or off. Press the Relay (06) button to switch

between gain and parameter. Once gain is selected, the button will light up and show the gain

value on the LCD display (15) will show the gain value blinking. If the parameter is selected, the

Relay (06) button will blink, just like the parameter value on the LCD display (15).

26) FX Select button

Pressing this button allows you to select one of the five effects as shown below.

Fig. 05

27) Title button

Pressing this button allows you to select one of the four display modes (MP-3 only) as shown below.

Fig. 06

Pressing and holding allows you to turn a playlist format using the Edit encoder (3).

Releasing this button results in entering the selected format.

Fig. 07

28) Time button

Press this button to switch the TIME indication on the LCD display (15) between the elapsed time and

remaining time. The selected mode is indicated by the ELAPSED or REMAIN.

29) Single button

Press this button to switch between the auto-cue mode and continuous play mode.

The selected mode is indicated by respectively Auto-CUE or CONTINUE in the LCD display (15).

In auto-cue mode, the unit stops playing after each track.

In continuous play mode, the unit plays all tracks and then stops.

30) Pitch Bend + button

The CD speeds up while pressing and holding this button. Release the button to return to the original

BPM.

31) Pitch Bend – button

The CD slows down while using and holding this button. Release the button to return to the original

BPM.

32) Pitch Control Fader

Use this fader to adjust the pitch. Move the fader upwards to decrease the pitch, move the fader

downwards to increase the pitch.

33) Range 8% LED

Indicates that the maximum range for the Pitch control fader (32) is ± 8%.

34) Range 16% LED

Indicates that the maximum range for the Pitch control fader (32) is ± 16%.

35) Brake button

Pressing and holding this button while turning the jog wheel allows you to set the start/break time

between 0,5 and 6 seconds. Arm the brake function by pressing the Brake (35) button, the

Brake (35) button lights up red indicating the brake function is armed. Pressing the Play/Pause (13)

button will actually trigger the start/break function.

36) Range button

Pressing this button allows you to change the maximum range for pitch control and lets you select a

range of ± 8%, ± 16% or ±100%.