User manual

Ordercode: D1155

CDMP-750

Program play

01) Press the Play/Pause (13) button to enter the pause mode.

02) Press the Prog. (05) button, the player will enter the program mode.

03) Select the desired track by rotating the Edit encoder (03), confirm by pressing the track encoder. The

selected track will be added to the program sequence.

04) Repeat the previous steps desired number of times. A maximum of 99 tracks can be programmed.

05) Press the Prog. (05) button to store the program sequence.

06) Use the Play/Pause (13) button to start/pause program play.

07) Press the Prog. (05) button again during program play to exit program play.

Press and hold the Prog. (05) button for more than 2 seconds to cancel the program play mode

and erase all the currently saved programs.

Loop play

01) Press the Loop In (17) button to set the start point of the loop, The Loop In (17) button will light up,

indicating that the start point is memorized.

02) Press the Loop Out (19) button to set the end point of the loop. The Loop Out (19) button will light up.

Once the end point is set; the playback will play the loop from start point to end point repeatedly.

Both the Loop In (17) and Loop Out (19) buttons will flash and RELOOP will appear on the LCD display

(15).

03) Pressing the Reloop/Exit (21) button will cancel the loop play function, the RELOOP indication on the

LCD display (15) will disappear and the Loop In (17) and Loop Out (19) button will stop flashing.

Set auto loop length

01) Press and hold the Rec (14) button. It will light up in red and the display will show AUTO.

02) Use the Jog wheel (10) to setup the number of bars you plan to record for the loop.

03) The range is 1/32 to 32 (32/1) bars. Default the loop length is 2/1.

Auto loop play

01) Press the Rec (14) button. The Rec (14) will light up in red and the display will show AUTO.

02) Press the Loop In (17) button to set the loop start point, Both the Loop In (17) and Loop Out (19)

buttons will flash and RELOOP will appear in the LCD display (15) indicating that the auto loop

playback is active.

03) Pressing the Reloop/Exit (21) button will cancel the loop playback function, the RELOOP indicator on

the LCD display (15) will disappear and the Loop In (17) and Loop Out (19) button will stop flashing.

Note: 1/1 equals one bar or 4 beats. When auto loop playback starts, the loop length is still editable by

using the Edit encoder (3).

Reloop

01) If you press the Reloop/Exit (21) button, the disc will return to the last selected loop.

02) Press the Loop In (17) button over and over rapidly to start the loop again and again.

03) Press the Reloop/Exit (21) button again, the loop play function is canceled, the LOOP indicator dims.