Operation Manual

Replacing the crossfader

1. Remove the four screws indicated by the solid line circles.

2. Gently remove the fader and disconnect the connector.

3. Re-attach the connector to the new fader and place the fader back gently.

4. Replace the fader cover and fix the screws.

Using the Core Mix-4 USB with PC software which can only access a single

soundcard

If the PC software you plan on using with the two USB1 (68) and USB2 (66) ports can only be set up with a

single soundcard, You need to install the freeware ASIO4ALL software which can be downloaded from

http://www.asio4all.com/ .

After installing the ASIO4ALL software, make sure the settings are the same as in figure 15.

Fig. 15

If you own a Mac, you can use the Audio Midi setup for this purpose.

Fig. 16