User manual

10
Ordercode: D2609
PSS-110 MKII
Installation
Remove all packing materials from the 110 MKII. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate an 115V specification product on 230V power, or vice versa.
Connections:
01) Turn off the power (31) switch.
02) Connect the PSS to your other devices you plan on using.
CAUTION: Be sure that the power is off, when connecting the cables.
Operating on AC power
● Make sure the power (31) switch is in the Off position and connect the power cable.
● Switch the power (31) switch in the On position to run the PSS. The power (16) LED will light red.
Operating on battery power
● Do not connect the power cable.
● Switch the power (31) switch to the On position to run the device.
● Switch the power (31) switch to the Off position if you’re pausing, to save your batteries.
● If the batteries are fully charged, the PSS can run on battery power for approximately 3-5 hours,
depending on the volume level.
● If the batteries run low and/or the orange LED of the battery level indicator (13) lights up, please turn
the PSS Off and recharge the battery.
Note:
The battery in the PSS should not be fully depleted. Charge it when it is low, but do not let it drain fully.
On the other hand, constant top off charging of a battery is never good.
Any charging adds heat and unfortunately heat degrades a battery. There is no escaping that.
Storage in a cool place slows the aging process of lithium-ion (and other chemistries). Manufacturers
recommend storage temperatures of 15°C.
Charging the built in batteries
● Make sure the power (31) switch is in Off position and connect the power cable.
● Switch the power (31) switch to the recharge position to charge the PSS’s internal batteries.
● While the PSS is charging, the red recharge (15) LED will light red.
● Charge the batteries for at least 8 hours. If the batteries are fully charged, the red recharge (15)
LED lights up continuously.