User manual

11
IMIX 7.2 USB
Ordercode: D2352
41. GND screw
Use to connect the ground wire of your turntable.
42. USB 2 port
This USB port can be used to connect the IMIX-7.2 to your PC/ laptop. The USB port is bidirectional, the
input can be assigned to channel 2 by means of the channel select (9) switch. The output of the USB port
is connected to rec A (35) output. This means that you’re only able record a channel with your software if
the channel is assigned to master A.
43. USB 1 port
This USB port can be used to connect the IMIX-7.2 to your PC/ laptop. The USB port is bidirectional, the
input can be assigned to channel 1 by means of the channel select (9) switch. The output of the USB port
is connected to rec A (35) output. This means that you’re only able record a channel with your software if
the channel is assigned to master A.
44. Master B XLR balanced out connectors
Use these outputs to connect an amplifier with balanced inputs.
45. Master A XLR balanced out connectors
Use these outputs to connect an amplifier with balanced inputs.
46. Display select switch
This switch allows you to setup a text for each RCA input. If the input is selected the text will be displayed
on the input display (17). You are able to assign following text: CD 1, CD 2, TUNER, DVD, TV, BEAMER, PC1,
PC2, DJ, AREA 2, AUX 1, AUX 2.
47. Channel gain control
Channel input level is determined by the gain control. With the gain control you are able to adjust the
line input-sensitivity for an optimal match with the mixer’s internal operation level. The high gain of this
mixer is ideal when dealing with very low input levels.
48. Mic 2 combo input connector
Electronically balanced combo-type input for connecting low impedance microphones. The input has
extremely low noise and low hum. When connecting a microphone make sure that the pin assignment is
correct. Always make sure to read the manual of the microphone you want to connect. The XLR- input is
not suitable for connecting an additional mixing console, FX- unit, etc. You have to use the line (54-58)
inputs, when connecting this kind of equipment.
Note: When connecting signal sources, please make sure the corresponding channel faders and the
master faders are at their minimum settings. Otherwise unpleasant plug-in noise can occur.
49. Mic 1 combo input connector
Depending on what’s most suitable in a given situation, you can use the Combo input at the front or the
rear. Both inputs are wired in parallel so you can even use them to link through.
Note: When connecting signal sources, please make sure the corresponding channel faders and the
master faders are at their minimum settings. Otherwise unpleasant plug-in noise can occur.