User manual

IMIX 7.2 USB

Ordercode: D2352

9. Input selection switch (channel 1/2)

With this you are able to assign the line (39/40) input

or the USB (42/43) input to the according channel. If

the line input is selected, the according channel

display (16) shows the text you have assigned to it

with the display select (16) switch. If the USB input is

selected, the channel display (16) shows USB 1 or

USB 2 depending on the channel.

10. Channel VU-meter

This meter is a multi-step LED. The accurate level

indication allows you to monitor the channel level

anytime. If the red LEDs frequently blink or constantly

light, the corresponding channel is likely to enter

clipping and you have to reduce the input’s

amplification using the gain control. Make sure that

the red LEDs light only briefly during dynamic peaks.

11/12/13. Equalizer section (channel 1-5)

The channel equalizer section allows shaping of the

incoming audio signal. All input channels are fitted

with 3-band EQ. The hi (2) and low (1) shelving

controls have their frequencies fixed at 12 KHz and

80 Hz respectively. The mid (3) range control has a

peaking response frequency at 1 KHz. All 3 bands

have up to 12dB cut and boost, with a centre

detent for off. Turning the equalizer control to the

right amplifies the frequency range; turning to the

left attenuates the signal. Minor changes to an

equalizer control usually produce the best results. Try

to avoid excessive enhancement of the mid band.

14. Input selection switch (channel 3/4)

With this you are able to assign two sets of line (37/38) inputs to the according channel. The according

channel display (16) shows the text you have assigned to it with the display select (16) switches.

15. Input selection switch (channel 5)

With this you are able to assign the line (36) input or the aux (26/28) inputs to the according channel. If

the line input is selected, the according channel display (16) shows the text you have assigned to it with

the display select (16) switch. If the aux (26/28) inputs are selected, the channel display (16) shows from

aux.

16. Input display

Shows the text you have assigned to the display using the corresponding display select (46) switch.

17. Channel fader

A logarithmic 50mm fader, which controls the volume of the corresponding channel. The overall volume

is set with the master control.