MSDS

SAFETY DATA SHEET
XIAMETER(R) SLT-7000 SEALANT OXIME CLEAR
Version
1. 1
Revision Date:
12/05/2014
MSDS Number:
643740-00002
Date of last issue: 10/17/2014
Date of first issue: 10/17/2014
5 / 18
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Ingredients with workplace control parameters
Ingredients CAS-No. Value type
(Form of
exposure)
Control parame-
ters / Permissible
concentration
Basis
Silicon dioxide 7631-86-9 TWA (Dust) 20 Million
particles per cubic
foot
(Silica)
OSHA Z-3
TWA (Dust) 80 mg/m3
/ %SiO2
(Silica)
OSHA Z-3
TWA 6 mg/m3
(Silica)
NIOSH REL
Hazardous components without workplace control parameters
Ingredients CAS-No.
Methyltri(ethylmethylketoxime)
silane
22984-54-9
Vinyltri (methylethylketoxime)
silane
2224-33-1
N-(3-
(Trimethoxysilyl)propyl)ethylen
ediamine
1760-24-3
Methyltri(ethylmethylketoxime)
silane isomers and oligomers
Not Assigned
Occupational exposure limits of decomposition products
Ingredients CAS-No. Value type
(Form of
exposure)
Control parame-
ters / Permissible
concentration
Basis
Ethyl methyl ketoxime 96-29-7 TWA 10 ppm DCC OEL
Further information: Skin sensitization
TWA 10 ppm US WEEL
Engineering measures
: Processing may form hazardous compounds (see section
10).
Ensure adequate ventilation, especially in confined areas.
Minimize workplace exposure concentrations.
Personal protective equipment
Respiratory protection : General and local exhaust ventilation is recommended to
maintain vapor exposures below recommended limits. Where
concentrations are above recommended limits or are
unknown, appropriate respiratory protection should be worn.
Follow OSHA respirator regulations (29 CFR 1910.134) and
use NIOSH/MSHA approved respirators. Protection provided
by air purifying respirators against exposure to any
hazardous chemical is limited. Use a positive pressure air
supplied respirator if there is any potential for uncontrolled
release, exposure levels are unknown, or any other