Instructions / Assembly

ManualsBrandsDAP ManualsOtherEclipse Wall Repair Patch 2 in.

PREP: Push in damaged or rough edges to the inside of

the wall and sand drywall damage smooth using

sandpaper. Make sure the area to be repaired is clean,

dry, firmed and free of any loose debris or materials.

PEEL: Using the easy-to-remove slit, remove the

patch from the back, white carrier sheet (like removing

a sticker) exposing the entire adhesive surface of the

patch.

PLACE: Position the gray center circle of the patch over

the center of the damage and smooth the patch to the

surrounding drywall using your hand. (Only press where the

patch is in contact with the drywall. DO NOT push through the damaged

area and do not pull the pop-up tab until after the first coat of paint.)

PAINT: Paint immediately using a high-quality paint

roller.

NO SPACKLING OR SANDING NECESSARY.

REMOVE: After first coat of paint is applied and

surrounding drywall is dry, remove clear protective layer

by pulling the pop-up tab.

FINISH: Apply two additional coats of paint for a smooth

and invisible repair. (Eclipse

can also be used on textured walls &

ceilings and will accept aerosol spray textures or textured paint rollers)

Simple & Fast Application

FOR BEST RESULTS: Make sure to follow the preparation instructions prior to completing the repair. After removing the protective layer, apply two

additional coats of paint. Using a primer coat will increase paint adhesion and improve dry time. Do not apply when temperatures are below 40°F. Not for

exterior use or on wet or damp surfaces.

Summary of content (1 pages)

PAGE 1
Simple & Fast Application PREP: Push in damaged or rough edges to the inside of the wall and sand drywall damage smooth using sandpaper. Make sure the area to be repaired is clean, dry, firmed and free of any loose debris or materials. PAINT: Paint immediately using a high-quality paint roller. NO SPACKLING OR SANDING NECESSARY. PEEL: Using the easy-to-remove slit, remove the patch from the back, white carrier sheet (like removing a sticker) exposing the entire adhesive surface of the patch.