Use and Care Manual

Performance Characteristics:

• Accelerated cure time allows exposure to water and moisture after only three hours without washing out.

• 100 waterproof which provides a permanently waterproof seal.

• Cured sealant is mold and mildew resistant.

• Won’t crack or shrink.

• Paintable with most acrylic latex paints. Use an acrylic primer before painting with oil-based paints. Sealant

reaches full cure in 24 hours. Restrain or limit any traffic until then.

Surface Preparation & Application:

1. Surface must be clean, dry and free of old caulk, dirt and debris.

2. Unscrew outer nozzle.

3. Cut inner nozzle at the thread point furthest away from the base of the nozzle.

4. Re-attach outer nozzle, & cut nozzle at a 45° angle to desired bead size.

5. Load cartridge into caulking gun. If gap is more than 1⁄2 inch deep, insert closed cell backer rod before

filling with sealant.

6. Apply by filling joints from bottom.

7. Protect sealant from rain or water for at least three hours before exposing to water. Sealant

surface may still be tacky.

8. Clean up excess uncured sealant from surface and tools with mineral spirits. Wash hands with soap and

water. Scrape or cut away excess cured sealant.

9. Paintable with most acrylic latex paints in 3 hours (surface may still be tacky). Use an acrylic primer for oil-

based paints.

10. Store partially used cartridge in a cool dry place. Use the DAP CAP™ (purchased separately) to smooth,

seal and finish caulk for professional results with no mess. Reseals cartridge for storage and reuse. When

ready to use again, remove the cured material at the tip or cut the tip back. Use as soon as possible,

preferably within a month.

or Best Results:

• Application temperature range is between 20°F and 120°F.

• Use on horizontal surfaces only.

• Not recommended for continuous underwater use or on stovepipes.

• Store product below 80°F (27°C) away from extreme heat and moisture.

• Certain porous substrates such as concrete may require primer for best adhesion.

Physical & Chemical Characteristics:

Vehicle: Advanced Polymer

Tooling Time: 20 minutes

Full Cure Time: 24 hours

Paintable: Yes

Odor: Very Mild

Consistency: Smooth and Creamy

Filler: Calcium Carbonate

Solids: >99.9% by weight

Weight per Gallon: 12.5 ±0.5 lbs/gallon

Service Temperature Range (Cured sealant): -65ºF to 200°F for continuous use, 250ºF with excursions

Application Temperature Range: 20ºF to 120ºF

Freeze Thaw Stability: Passes 5 Cycles 0ºF (1 cycle = 16 hrs. @ 0ºF, 8 hrs. @ 70ºF)

Shelf Life: 12 months if unopened and stored in cool dry place

Coverage: 49 linear feet at 3/16” diameter bead

MSDS No: 000 10050 001