MSDS
Keep containers closed when not in use. Use in well ventilated area. Provide fresh air such that chemical odors cannot be
detected during use and while drying. Do not get in eyes, on skin or clothing. Keep away from heat. Wash thoroughly after
handling. Do not smoke. Intentional misuse by deliberately concentrating and inhaling vapors may be harmful or fatal.
Storage: Keep away from heat and sources of ignition. Avoid excessive heat and freezing. Do not store at temperatures
above 120 degrees F. Store away from caustics and oxidizers.
Precautionary Measures: Please refer to other sections and subsections of this MSDS.
Engineering Controls: Vapors are heavier than air and may spread along floors. Provide sufficient general and/or local
exhaust ventilation to maintain exposure below recommended exposure limit. Ensure fresh air entry during application
and drying. If you experience eye watering, headache or dizziness or if air monitoring demonstrates vapor/mist levels are
above applicable limits, wear an appropriate, properly fitted respirator (NIOSH approved) during and after application.
Follow respirator manufacturer's directions for respirator use.
Respiratory Protection: A NIOSH-approved air purifying respirator with an organic vapor cartridge or canister may be
necessary under certain circumstances where airborne concentrations are expected to exceed exposure limits. A
respiratory protection program that meets the OSHA 1910.134 and ANSI Z88.2 requirements must be followed whenever
workplace conditions warrant a respirator's use. If you experience eye watering, headache or dizziness or if air monitoring
demonstrates vapor/mist levels are above applicable limits, wear and appropriate, properly fitted respirator (NIOSH
approved) during and after application.
Skin Protection: Impervious gloves.
Eye Protection: Goggles or safety glasses with side shields.
Other protective equipment: Provide eyewash and solvent impervious apron if body contact may occur.
Hygienic Practices: Remove and wash contaminated clothing before re-use. Do not smoke.
Important: Listed Permissible Exposure Levels (PEL) are from the U.S. Dept. of Labor OSHA Final Rule Limits (CFR 29 1910.1000); these limits may vary
between states.
Note: An employee's skin exposure to substances having a "YES" in the "SKIN" column in the table above shall be prevented or reduced to the extent
necessary under the circumstances through the use of gloves, coveralls, goggles or other appropriate personal protective equipment, engineering controls or work
practices.
When reported, vapor pressure of this product has been calculated theoretically based on its constituent makeup and has not been determined experimentally.
(See section 16 for abbreviation legend)
Section 8 - Exposure Controls / Personal Protection
Chemical Name
CASRN
ACGIH TWA
ACGIH STEL
ACGIH CEIL
OSHA TWA
OSHA STEL
OSHA CEIL
Skin
Hydrogenated petroleum resin
69430
-
35
-
9
N.E.
N.E.
N.E.
N.E.
N.E.
N.E.
No
Xylenes
1330
-
20
-
7
100 PPM
150 PPM
N.E.
100 PPM
N.E.
N.E.
No
Ethyl benezene
100
-
41
-
4
20 PPM
125 PPM
N.E.
100 PPM
N.E.
N.E.
No
Bis(1,2,2,6,6
-
pentamethyl).seb
41556
-
26
-
7
N.E.
N.E.
N.E.
N.E.
N.E.
N.E.
No
Methyl(1,2,2,6,6
-
penta...)seb
82919
-
37
-
7
N.E.
N.E.
N.E.
N.E.
N.E.
N.E.
No
Section 9 - Physical And Chemical Properties
Boiling Range:
Not Established
Vapor Density:
Heavier Than Air
Odor:
Strong Solvent
Odor Threshold:
Not Established
Color:
Clear
Evaporation Rate:
Faster Than n
-
Butyl Acetate
Solubility in H2O:
Not Established
Specific Gravity:
0.89
-
0.89
Freeze Point:
Not Established
pH:
Not Applicable
Vapor Pressure:
Not Established
Viscosity:
Not Established
Physical
State
:
Paste
Flammability:
Flammable
Flash Point, F:
81
Method:
(
Seta Closed Cup)
Lower Explosive Limit, %:
Not Determined
Upper Explosive Limit, %:
Not Determined
Page
3
of
6
00077019004English