Use and Care Manual

2
Adheres To:
 Ceramic/Porcelain
 Glass
 Most Plastics
 Granite, Cultured Marble & Natural Stone
 Wood
 Metal
 Drywall
 Fiberglass
 Painted Surfaces
Performance Characteristics:
 Repels water, stains and dirt
 Lifetime mold & mildew guarantee
 Sealant stays looking fresh & new
 Water ready in 4 hours
 100% waterproof
 Crack & stain proof
 Safe for granite & marble
 Easy water clean up and low odor
 Not paintable
 Sealant applies white and dries clear in 7-14 days (depending on joint depth, temperature and
humidity).
For Best Results:
 Apply in temperatures above 40F.
 Not for continuous underwater use, high temperature surfaces or surface defects.
 Joint size should not exceed 3/8” wide by 3/8” deep. For joints deeper than 3/8”, use backer rod.
 Store product away from extreme heat or cold.
Surface Preparation & Application:
1. Surface must be clean, dry and free of all old sealant, dirt, dust, debris and grease. Rubbing alcohol is
recommended for removing soap film and soil.
2. Remove cap (from tube). Cut nozzle at a 45 angle to desired bead size. If using the cartridge, puncture
inner foil seal and load into caulk gun.
3. Fill gap with sealant, pushing sealant ahead of nozzle.
4. For a neat finish, smooth bead of sealant with a finishing tool.
5. Allow sealant to dry for at least 4 hours before exposing to water. Sealant reaches full performance in 24
hours.
6. Clean up excess uncured sealant with damp sponge before it skins over. Scrape or cut away excess cured
sealant.
7. Regular cleaning of surrounding areas is suggested.
8. Reseal tube/cartridge for future use.
Physical & Chemical Characteristics:
Tooling Time: 3-5 minutes
Tack Free Time: 7-10 minutes
Paintable: No
Odor: Very Mild
Consistency: Smooth and Creamy
Vehicle: Acrylic Polymer
Volatile: Water
Flash Point: None
Filler: Titanium Oxide
Density: 1.03
Solids: 58% by weight