MSDS

Steps To Be Taken If Material Is Released Or Spilled: Wear proper protective equipment as specified in Section 8. If
spilled, contain spilled material and remove with inert absorbent. Dispose of contaminated absorbent, container and
unused contents in accordance with local, state and federal regulations.
Handling: KEEP OUT OF REACH OF CHILDREN! DO NOT TAKE INTERNALLY. Use only with adequate ventilation.
Open all windows and doors or use other means to ensure cross-ventilation and fresh air entry during application and
drying. Odor is not an adequate warning for hazardous conditions. Avoid breathing vapor and contact with eyes, skin and
clothing. Wash thoroughly after handling.
Storage: Do not store at temperatures above 120 degrees F. Store containers away from excessive heat and freezing.
Close container after each use. Store away from caustics and oxidizers.
Exposure Notes: 50-00-0 Formaldehyde is a specially regulated substance for which an OSHA chemical-specific
exposure standard exits. Detailed information regarding this substance may be found in 29 CFR 1910.1048. Medical
surveillance information regarding this substance may be found in Appendix C to 29 CFR 1910.1048.
Precautionary Measures: Please refer to other sections and subsections of this MSDS.
Engineering Controls: Good general ventilation should be sufficient to control airborne levels. Ensure adequate
ventilation, especially in confined areas. Local ventilation of emission sources may be necessary to maintain ambient
concentrations below recommended exposure limits.
Respiratory Protection: In case of insufficient ventilation, wear suitable respiratory equipment. A NIOSH-approved air
purifying respirator with an organic vapor cartridge or canister may be necessary under certain circumstances where
airborne concentrations are expected to exceed exposure limits. A respiratory protection program that meets the OSHA
1910.134 and ANSI Z88.2 requirements must be followed whenever workplace conditions warrant a respirator's use.
Skin Protection: Rubber gloves.
Eye Protection: Goggles or safety glasses with side shields.
Other protective equipment: Not required under normal use.
Hygienic Practices: Wash hands before breaks and at the end of workday. Remove and wash contaminated clothing
before re-use.
Important: Listed Permissible Exposure Levels (PEL) are from the U.S. Dept. of Labor OSHA Final Rule Limits (CFR 29 1910.1000); these limits may vary
between states.
Note: An employee's skin exposure to substances having a "YES" in the "SKIN" column in the table above shall be prevented or reduced to the extent
necessary under the circumstances through the use of gloves, coveralls, goggles or other appropriate personal protective equipment, engineering controls or work
practices.
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Chemical Name
CASRN
ACGIH TWA
ACGIH STEL
ACGIH CEIL
OSHA TWA
OSHA STEL
OSHA CEIL
Skin
Styrene
100
-
42
-
5
20 PPM
40 PPM
N.E.
100 PPM
N.E.
200 PPM
No
Ethylene glycol
107
-
21
-
1
N.E.
N.E.
100 MGM3
N.E.
N.E.
N.E.
No
Formaldehyde
50
-
00
-
0
N.E.
N.E.
0.3 PPM
0.75 PPM
2 PPM
N.E.
No
Section 9 - Physical And Chemical Properties
Boiling Range: Not Established Vapor Density: Heavier Than Air
Odor:
Very Slight Ammonia
Odor Threshold:
Not Established
Page
3
of
6
00077314001 English.htm