MSDS
When reported, vapor pressure of this product has been calculated theoretically based on its constituent makeup and has not been determined experimentally.
(See section 16 for abbreviation legend)
Conditions To Avoid: Excessive heat and freezing.
Incompatibility: Incompatible with strong bases and oxidizing agents.
Hazardous Decomposition Products: Normal decomposition products, i.e., COx, NOx.
Hazardous Polymerization: Hazardous polymerization will not occur under normal conditions.
Stability: Stable under recommended storage conditions.
Significant Data with Possible Relevance to Humans: This product contains trace amounts of free formaldehyde.
OSHA and NTP identify formaldehyde as a potential carcinogen. IARC identifies formaldehyde as a human carcinogen.
Formaldehyde has been shown to cause mutations in a variety of in-vitro test systems, the significance of which to
humans is unknown. There should be minimal risk when used with ventilation adequate to keep the atmospheric
concentration of formaldehyde below the recommended exposure limits.
Maintain adequate ventilation to prevent exposure above current OSHA / ACGIH exposure limits. Workplace monitoring of
the air to define formaldehyde exposure levels may be necessary.
In a two-year inhalation study, rats showed carcinogenic effects in the respiratory system at 15 ppm of formaldehyde.
Ecological Information: Ecological injuries are not known or expected under normal use.
Disposal Information: Dispose of material in accordance with all federal, state and local regulations. State and Local
regulations/restrictions are complex and may differ from Federal regulations. Responsibility for proper waste disposal is
with the owner of the waste.
EPA Waste Code if Discarded (40 CFR Section 261): This product does not meet the definition of a hazardous waste
according to U.S. EPA Hazardous Waste Management Regulation, 40 CFR Section 261.
Color:
White ( changes to clear as it
cures )
Evaporation Rate:
Slower Than n
-
Butyl Acetate
Solubility in H2O:
Not Established
Specific Gravity:
1.1
Freeze Point:
Not Established
pH:
Between 7.0 and 12.0
Vapor Pressure:
Not Established
Viscosity:
Not Established
Physical
State
:
Paste
Flammability:
Non
-
Flammable
Flash Point, F:
Greater than 200
Method:
(
Seta Closed Cup)
Lower Explosive Limit, %:
Not Established
Upper Explosive Limit, %:
Not Established
Section 10 - Stability And Reactivity
Section 11 - Toxicological Information
Product LD50: Not Established
Product LC50: Not Established
CASRN
Chemical Name
LD50
LC50
100
-
42
-
5
Styrene
-------------
Rat:12 gm/m3/4H
107
-
21
-
1
Ethylene glycol
Rat:4700 mg/kg
Rat:10876 mg/kg
50
-
00
-
0
Formaldehyde
-------------
Rat:203 mg/m3
Section 12 - Ecological Information
Section 13 - Disposal Information
Section 14 - Transportation Information
Page
4
of
6
00077314001 English.htm